All the screws of the Lemontron in one place! Don't drop them!

Chassis Screws

Type Thread Length Qty Use
button-head M3 5mm 8 Used to secure the Z axis rails to the z axis mount
button-head M3 14mm 2 For fixing the Z axis assembly to the chassis
button-head M3 14mm 8 For fixing the Y axis rails to the chassis
button-head M3 14mm 8 For fixing the fans to the fan mounts
button-head M3 14mm 2 For fixing the AC plug to the chassis
button-head M3 25mm 4 Used to attach the Z axis bracket & bed holder to the carriage
button-head M3 25mm 4 For fixing the idler bearings to the chassis
countersunk M3 6mm 1 Used as the bearing shaft in the Lemonstruder
countersunk M3 8mm 15 For the motor mounts
countersunk M3 8mm 1 Adjustment screw for the top of the Z block
countersunk M3 8mm 1 For the Z axis lead screw nut
countersunk M3 15mm 4 To secure the top plate to the unibody chassis
countersunk M3 25mm 6 Used to secure the Y axis motor mounts to the unibody chassis
countersunk M3 20mm 2 Used to secure the mid plates to the unibody chassis
countersunk M3 35mm 4 Stiffens the unibody chassis and double as adjustment screws

Toolhead Screws

Type Thread Length Qty Use
countersunk M2.5 6mm 4 Used to attach the hot end to the tool head
countersunk M2.5 6mm 2 Used to attach the probe to the tool head
countersunk M2.5 10mm 2 Used to attach the belt clip to the tool head
countersunk M3 16mm 2 Used to attach the tool head to the X axis carriage
button-head M3 10mm 1 Used to secure the wire clamp on the tool head

These screws are found within the button head screws box and countersink head screws box. But unfortunately the 25mm button head screws and 15mm countersunk screws must be ordered separately. If desired, you can just make 15mm screws by cutting longer ones.

download Download CSV