MGN9C X-Axis Rail
250mm
$9.41
Estimated Total
× 1
The smallest rail in the BOM allows the tool head to travel left and right.
Required Modification
Trim off one hole! Suggested to use a Dremel & cutoff wheel or a hacksaw. The rail will wind up around 230mm.
Zesty Tip
When dealing with linear rails, it's important to not drop the balls! Take caution and put temporary end stops
on the rail.
And, rails are not pre-lubricated from the factory. The factory oil is primarily intended to prevent corrosion and should be removed using alcohol. After cleaning, lubricate the rails with Teflon or lithium grease for optimal performance.
And, rails are not pre-lubricated from the factory. The factory oil is primarily intended to prevent corrosion and should be removed using alcohol. After cleaning, lubricate the rails with Teflon or lithium grease for optimal performance.